Bottom Cover And Accessories; Before You Begin; Prepare The Required Hardware And Tools - Ruckus Wireless ZONEFLEX 2741 Getting Started Manual

Bottom Cover and Accessories

Bottom cover of the Access Point
■
DC terminal block
■
Black solid rubber stoppers (2 pieces)
■
Black rubber O-ring
■
Green rubber O-ring
■
White P-clip cable clamp (2 pieces)
■
Machine screws (2 pieces)
■
Machine screws with washers (3 pieces)
■
3

Before You Begin

Before installing and setting up the Access Point, Ruckus Wireless recommends that you
first complete the following pre-installation tasks.

Prepare the Required Hardware and Tools

You must supply the following tools and equipment:
A notebook computer running on Windows XP/2000 and installed with one wireless
■
802.11b/g network card and one Ethernet card
6mm flathead screwdriver
■
6mm Phillips screwdriver
■
10mm ratchet wrench
■
3mm Phillips screwdriver (if you will be using DC power)
■
Electric drill with 8mm drill bit (if mounting on a flat surface)
■
NOTE: At the beginning of each procedure, this guide lists the specific tools, accessories,
and equipment that you will need to complete the procedure.
Before You Begin
Prepare the Required Hardware and Tools
3