Attaching The Mounting Brackets; What You Will Need; Step 1: Attach The Static Bracket To The Mounting Surface; Attaching The Bracket To A Flat Surface - Ruckus Wireless ZoneFlex 2741 802.11g Getting Started Manual

Attaching the Mounting Brackets

What You Will Need

7
Attaching the Mounting Brackets
What You Will Need
To complete this procedure, you will need the following items:
Static bracket
■
Dynamic bracket
■
Wall anchors
■
Flat washers
■
Hex nuts
■
10mm ratchet wrench
■
If you are mounting the Access Point on a flat surface, you will also need an electric drill
with an 8mm drill bit.
If you are mounting the Access Point on a pipe or pole, you will also need the following:
A 30mm to 60 mm (1.18 in. to 2.36 in.) pipe or pole
■
Steel clamp
■
10mm flathead screwdriver
■
Step 1: Attach the Static Bracket to the Mounting
Surface
The procedure for attaching the bracket to the mounting surface depends on whether you
are mounting the Access Point to a flat surface or a pole.

Attaching the Bracket to a Flat Surface

■
Attaching the Bracket to a Pole
■
Attaching the Bracket to a Flat Surface
WARNING: Ruckus Wireless strongly recommends that you wear eye protection before
drilling holes on the mounting surface.
NOTE: The wall anchors that are supplied with the Access Point are for mounting on solid
masonry walls only. If you are mounting the Access Point on other materials (for example,
drywall, wood, or hollow cinder block), you will need the appropriate types of wall anchors.
Check your local hardware store for options.
40