Ruckus Wireless ZoneFlex 2741 802.11g Getting Started Manual page 37

Use Power Over Ethernet
1. Take out the PoE injector and the power adapter from the Access Point package.
2. Obtain three Ethernet cables. Two of these Ethernet cables must be outdoor-rated.
3. Connect one end of the outdoor-rated Ethernet cable to the RJ45 port on the Access
Point, and then connect the other end to a port on the Ethernet surge suppressor.
4. Connect one end of another Ethernet cable to another port on the Ethernet surge
suppressor, and then connect the other end to the PoE Out port on the PoE injector.
NOTE: Install the Ethernet surge protector between the Access Point and the PoE injector
and use two outdoor-rated Ethernet cables for the connections. See
example.
5. Connect one end of the other Ethernet cable to the LAN port on the PoE injector, and
then connect the other end to your network.
6. Connect the power jack to the DC 48V IN connector on the PoE injector.
WARNING: Do not apply power to the Access Point at this point. You should connect the
Access Point to a power source only after you finish connecting all other components in
"Step 3: Connect the Access Point to the Network"
Figure 20. Connect the Ethernet cables and power adapter to the PoE injector
To Admin Computer
7. Wrap the white P-clip cable clamp around the Ethernet cable, and then fasten it to the
Access Point chassis using one of the short machine screws supplied with the Access
Point.
Step 1: Complete the Power Connections
on page
To AC Power Source
Deploying the Access Point
Figure 25 for an
38.
To Ethernet
Surge Protector
33