Ruckus Wireless ZoneFlex 2741 802.11g Getting Started Manual page 28

Configuring the Access Point
Configuring for Standalone Operation or for Management by FlexMaster
Figure 14.
Ground Wire to
V- Terminal
5. Using a 3mm Phillips screw, tighten the wiring terminal screws. Screw torque value must
be 4kg-5kg.
6. Connect the DC terminal block to the 12V DC port on the Access Point.
Figure 15.
7. Connect the DC cable to a DC power source (for example, a battery).
You have completed connecting the Access Point to the administrative computer and to
a DC power source.
24
Connect the ground wire to the V- terminal and the +12v DC wire to the V+
terminal
Connect the DC terminal block to the 12V DC port
12V DC Wire to
V+ Terminal