Step 2: Connect The Access Point To The Same Subnet As Zonedirector; Step 5: Disconnect The Access Point From The Power Source - Ruckus Wireless ZoneFlex 2741 802.11g Getting Started Manual

Step 2: Connect the Access Point to the Same Subnet as
ZoneDirector
1. Verify that the Access Point is powered on.
1. Connect the Access Point to the same Layer 2 subnet as ZoneDirector. The same Layer
2 subnet means that there should not be any router between the Access Point and
ZoneDirector.
2. Log into ZoneDirector, and then go to the Monitor > Access Points page.
3. Look for the MAC address of the Access Point, and then check its Status column.
• If automatic approval is enabled, the Status column should show Connected.
• If automatic approval is disabled, click the Allow link that is on the same row as the
Access Point's MAC address. This allows the Access Point to register with ZoneDi-
rector.
When the Status column shows Connected, this indicates that the Access Point has
successfully registered with ZoneDirector and that it can now be moved to its destination
Layer 2 or Layer 3 network.
Step 5: Disconnect the Access Point from the Power
Source
1. Disconnect the Access Point from the power source (either from the PoE injector or
DC power source).
2. Verify that the PWR LED on the back of the Access Point is off.
3. Continue to "Attaching the Mounting Brackets"
Configuring the Access Point
Configuring for Management by ZoneDirector
on page 40.
19