Viewing The Snmp Event Log; Before You Begin Installing The Cmap; Prepare The Required Hardware And Tools - Ruckus Wireless ZoneFlex 7761-CM Installation Manual

Viewing the SNMP Event Log

1. If not already done, log into to the Status page as described in
Web Interface using Dynamic IP"
using the CMAP Ethernet Port"
2. Click Event Log on the menu on the left sidebar. The CM web interface displays the
SNMP Event Log Status page.
3. View the SNMP events in the SNMP event log.
Figure 30. SNMP Event Log Status page
7

Before You Begin Installing the CMAP

Before installing and setting up the CMAP, Ruckus Wireless recommends that you first
complete the following pre-installation tasks.

Prepare the Required Hardware and Tools

You must supply the following tools and equipment:
A notebook computer running Windows 7/Vista/XP with one wireless 802.11b/g/n
■
network card and one Ethernet card installed
Coaxial cable with a male F connector (connected to the CMTS backbone)
■
If you plan to use DC to power the CMAP (for staging or debugging only), you need
■
a DC power supply (see DC Power Supply in
Before You Begin Installing the CMAP
on page 40 or "Logging Into the CM Web Interface
on page 40.
"Connectors"
47
Viewing the SNMP Event Log
"Logging Into the CM
on page 34).