Printing Permit Mail; How To Correct The Postage Value (Running Mail) - Neopost IS-5000 Operator's Manual

Running Mail
Once you have completed setting up your Impression, follow the instructions below to
process your Postage Value Correction Impression.

How to correct the Postage Value (Running Mail)

3
To print a Postage Value Correction Impression:
1.
Press
Insert the mail piece(s) into the mail path against the rearguide wall, side to be printed
2.
facing upwards (see
If your mail piece is larger than mail path's maximum thickness (see
on page 277 ), press
If you want to print several multiple Labels:
1.
Press
Make sure the Label Dispenser is full (see
page 96 ).
2.
Press

Printing Permit Mail

In this Section
This section describes the system settings to be selected and the mail preparation steps
to be completed in order to print a Permit Mail Meter Impression.
To use a permit, you need it to be pre-loaded in the Mailing System. See :
Managing Permit Impressions
•
The instructions below outline the steps that you need to complete to set up your system
to print a Permit Mail Meter Impression.
• As mail requirements differ from day to day, some of the Impression Options may
not be necessary, or their order may vary.
• Begin by selecting a Meter Impression to gain access to the Impression Options that
you may need to process your Permit Mail.
62
. The system motors will start running.
How to use the Feeder
before you press
and enter the number of Labels you wish to print.
to print your Labels.
Make sure you have completed the preparation steps mentioned
in Sorting Mail by Type and Task
on page 91).
to print a Label. The Label is printed.
Filling the Automatic Label Dispenser
on page 238 .
on page 40.
Mail Specifications
on