Configuring The Dvb-S/S2 Input Port Properties - Harmonic ProView 7000 User Manual

Topics:

Configuring the DVB-S/S2 Input Port Properties

■
Configuring the Decoding
■
Routing and Descrambling
■
Configuring the GbE Ports, Sockets and Routing Table
■
CA Definitions
■
Unit Menu
■
Presets
■
4.1 Configuring the DVB
To configure the ProView 7000™ reception parameters:
1. Navigate Root > Reception.
2. If your device has more than one demodulator, select a satellite input menu, SAT 1–4.
3. Select Configuration.
Each menu item displays a value setup page.
The Configuration menu comprises the following:
Universal/Wide Universal/K
■
frequency according to the satellite LNB transmitting frequency. The receiver controls the
LNB band by sending a 22 kHz signal. When the signal is sent, the LNB uses its High Band
Local Oscillator (L.O.). When the signal is not sent, the LNB uses its Low Band L.O.
Two local oscillators exist, Universal and Universal Wide one for each band to leverage full
spectrum.
Universal Band valid range:
❑
• 22 kHz Low tone range – 10,700,000 – 11,900,000 [kHz]
• 22 kHz High tone range – 11,550,000 – 12,750,000 [kHz]
Wide Universal Band valid range:
❑
• 22 kHz Low tone range – 10,700,000 – 11,900,000 [kHz]
• 22 kHz High tone range – 11,700,000 – 12,750,000 [kHz]
K Band valid range (22 kHz Low and High tone) – 9,500,000 – 14,000,000 [kHz]
❑
u
C Band valid range (22 kHz Low and High tone) – 4,000,000 – 5,000,000 [kHz]
❑
L Band Frequency (DVB-S and DVB-S2) – Sets the L-band frequency
■
Valid range – 950,000 to 21,150,000 [kHz].
Symbol Rate – DVB-S and DVB-S2. Sets the L-band symbol rate.
■
Valid range – 1,000,000 – 45,000,000 [baud].
© 2012 Harmonic Inc.
Device Configuring Using the Front Panel
-S/S2 Input Port Properties
/C Band Frequency (DVB-S and DVB-S2) – Sets the receiving
u
36
Chapter 4
ProView 7000 v.2.6, Rev. E