Chapter 4 Device Configuring Using the Front Panel
You can use any multiplex for routing.
Each multiplex menu comprises the following sub-menus:
Activation
■
Enable – Enable the multiplex and automatically create a TS cross connect to the
❑
corresponding multiplex out. If the corresponding multiplex out already has a program
on it, it is removed. If the corresponding multiplex out already has a TS on it, the
multiplex in cross connects with the first available multiplex out.
Disable – Only removes the TS cross connect from the multiplex out, the multiplex
❑
remains enabled.
Redundancy Mode
■
Off
❑
Manual
❑
Manual Revert
❑
Automatic
❑
Automatic Revert
❑
Active Input – Use this menu to display or change the active input port.
■
Primary Input – When using multiplex input port redundancy use this menu to select one of
■
the following physical input ports for the primary input, Redundancy Mode must be set to
any mode but Off:
SAT 1
❑
8
SAT 2
❑
SAT 3
❑
SAT 4
❑
ASI 1
❑
ASI 2
❑
9
ASI 3
❑
9
ASI 4
❑
Socket 1
❑
Socket 2
❑
Socket 3
❑
Socket 4
❑
Backup Input– When using multiplex input port redundancy use this menu to select one of
■
the following physical input ports for the backup input, Redundancy Mode must be set to
any mode but Off:
SAT 1
❑
8
SAT 2
❑
SAT 3
❑
SAT 4
❑
8.
The number of RF satellite inputs depends on your hardware configuration.
9.
ProView 7000™
© 2012 Harmonic Inc.
47
Routing and Descrambling
ProView 7000 v.2.6, Rev. E