Initial Setup; Configuring The Ip Parameters - Harmonic ProView 7000 Quick Setup Manual

Power Up
Before powering up the ProView 7000, make sure that all cables are correctly connected.
Ensure that the unit is connected to the main power supply and correctly grounded.
When you power it up, you will hear the internal fans start and see the front panel LCD
display light up. Once the unit is powered up, it begins automatic initialization, which includes
loading embedded system parameters. This process takes 2 to 3 minutes.
When the boot process is complete,
Initial Set-Up
You need to use the ProView 7000 front panel to configure the IP parameters.

Configuring the IP Parameters

To configure the IP parameters of a ProView 7000:
1. Press
Enter
The root menu displays.
2. Navigate
1 IP Address
2 Subnet Mask
3 Default Gateway
3. Set the IP Address, Subnet Mask and Default Gateway for the port.
4. After any change in the IP configuration, the
Configuration sub-menu to allow confirmation of the port setup.
5. Select
4 Apply port changes
6. Select
1 Apply Changes
© 2010 Harmonic Inc.
Status OK
Status OK
on the keypad.
7 Unit > 1 Management Port > 1 IP Configuration
IP Configuration
.
to apply or
Power Up
displays on the front panel screen.
No Service Selected
.
4 Apply port changes
to abort the configuration.
2 Drop Changes
2
1-7-1-1
127.000.000.010
255.255.255.000
000.000.000.000
item is added to the IP
ProView 7000, v.2.3, Rev. A