Hardware Properties - Harmonic ProView 7000 User Manual

Chapter 7 Device Configuring Using EMS
To add or edit a routing entry:
1. Click Edit Entry.
The Routing Table Entry dialog displays.
2. Select the destination type, network or host.
3. Enter the following:
Destination Address
❑
Mask
❑
Gateway – Enter the GbE IP address that corresponds to the selected GbE port.
❑
4. Select the Port.
5. Click OK.
To clear a routing entry:
1. Select a routing entry.
2. Click Clear Entry.
3. Confirm.
7.11.2

Hardware Properties

The Hardware properties tab provides the EMS user the ability to monitor the following
parameters related to the ProView 7000™ unit, arranged in the following groups / sub-tabs:
NOTE: Each Hardware Properties sub-tab also displays the highest active alarm level related to the
ProView 7000™ device.
Device Box
The Device box displays the device model name.
Hardware Inventory Box
The Hardware Inventory Box contains the following tabs:
Platform
■
Main Board
■
Front End
■
Bottom Card
■
Top Card
■
© 2012 Harmonic Inc. 155
Device Properties
ProView 7000 v.2.6, Rev. E