Harmonic ProView 7000 User Manual page 131

Chapter 7 Device Configuring Using EMS
7.6.1.2 Program Cross Connection
You can cross connect programs from a multiplex in the Multiplex Input box with a multiplex
in the Multiplex & Decoding Output box and configure CAM descrambling.
The following options are available in the Dynamic Program Connection Configuration dialog:
Enabled – Define the operational status of the program.
■
Input – Display the name of the input multiplex which receives the stream and the number
■
of the multiplex program.
Output – Display the name of the output multiplex port where the stream is routed, the
■
number of the multiplex program routed to the port and the PID offset.
Descrambling – Enable descrambling the program and select the CAM used for the
■
descrambling. If no CAM is associated it is indicated here.
ES Descrambling – To use this feature you must first configure the Descrambling box. There
■
are two descrambling modes to choose from, the default is Automatic:
Automatic – All ESs in this program with a CAS ID that matches the CAM are configured
❑
for descrambling.
Selective – Select which input PIDs to descramble. You can add PIDs which are not in the
❑
table. You must check at least one ES PID.
© 2012 Harmonic Inc. 131
Cross Connections
ProView 7000 v.2.6, Rev. E