Upgrading The Firmware Of Proview 7000S; Viewing The Software Upgrade Log - Harmonic ProView 7000 User Manual

Appendix F Software Management
F.2.1

Upgrading the Firmware of ProView 7000s

It is recommended to upgrade all ProView 7000™s at the same time. A device must be
connected to be able to upgrade it, see
successfully completed, the devices reboot and EMS closes. It takes several minutes to
upgrade a device. The new version loads into the inactive firmware slot and does not replace
the active version.
To upgrade the firmware of several ProView 7000™s:
1. Select Tools > Firmware Software Upgrade Manager.
The Software Upgrade Manager dialog displays.
2. Mark the Upgrade checkboxes of the devices that you want to upgrade.
—or—
To upgrade many devices:
a. Click
b. Click
3. Open the Upgrade File browser and browse to the zip file containing the new software on
your local hard disk.
4. Click Select.
5. Click Start Upgrade.
6. When the upgrade is complete, wait a few minutes for devices to reboot then upgrade
your EMS installation to the same version of the managed devices:
Refresh the web page with the ProView 7000™ IP address.
a.
b. Click
To upgrade your EMS installation to the same version of the managed devices:
1. Run a web browser and enter a ProView 7000™ IP address.
The initial ProView 7000™ dialog displays.
2. Click Launch ProView 7000™ EMS on the ProView 7000 web page to install the EMS.
The EMS application installs.
F.2.2

Viewing the Software Upgrade Log

To view the software upgrade log:
1. Select Tools > Firmware Software Upgrade Manager.
The Software Upgrade Manager dialog displays.
2. Click Log.
The Activity Log dialog displays.
© 2012 Harmonic Inc.
Remove to remove device names that are not part of the upgrade.
Select All to select all devices in the list.
Launch ProView 7000™ EMS
6.7 Connecting a Device. Once the device upgrade is
on the ProView 7000 web page to install the EMS.
201
Software Upgrade Manager
ProView 7000 v.2.6, Rev. E