Wall Mounting - Avaya IP Office Essential Edition Installation Manual

4.6 Wall Mounting

PARTNER Version Installation Manual
IP Office Essential Edition
The IP Office 500v2 control unit can be wall mounted. This requires an IP
Office 500 Wall Mounting Kit (SAP 700430150) plus additional 4.5mm
fixtures and fittings suitable for the wall type. The wall mounting kit
includes two brackets, one top and one bottom.
Environmental Requirements
In addition to the existing
Essential Edition - PARTNER® Version system, the following additional
requirements apply when wall mounting a unit:
The wall surface must be vertical, flat and vibration free.
·
A minimum clearance of 500mm (19.7 inches) is required on
·
all sides.
The unit must be orientated as shown when mounted. That is
·
with the base card slots facing right when viewed from in front of
the unit.
The brackets must be used as shown, with the deeper tray-like
·
bracket used at the bottom of the wall mounted control unit.
Only the screws (M3 x 6mm) provided with the mounting kit
·
should used to attach the brackets to the control unit.
environmental requirements
- Issue 1c (09 April 2010)
for an IP Office
Page 48