7.3.1 Analog Phone
This card is used to add analog phone extension ports to an IP500 and IP500 V2 control unit. It is available in two
variants, providing either 2 or 8 analog extension ports.
Features
Analog Extension: Ports 1 to 8
· Supports ICLID modes DTMFA, DTMFC, DTMFD, FSK and
UK20.
· REN 2 (1 for external bell device).
· Off-Hook current: 25mA
· Ring Voltage: 40V.
· Intended for connection to two-wire analog phones, the
ports do not include a ringing capacitor. For connection to
4-wire analog phones, connection should be via a master
socket with ringing capacitors.
· If fitted with an analog trunk card, for the Phone 8, during
power failure extension port 8 is connected to the analog
trunk port 12.
Optional Trunk Card Ports: Ports 9 to 12
The card can be fitted with one of the following trunk
daughter cards. The trunk daughter card then uses ports 9 to
12 on the base card for its trunk connections.
· IP500 Analog Trunk Card.
· IP500 PRI Trunk Card.
Name
IPO 500 Extn Card Phone 2
IPO 500 Extn Card Phone 8
PARTNER Version Installation Manual
IP Office Essential Edition
· Supports
Provides either 8 or 2
· Maximum per IP500 Control Unit: 4.
· IP500 Daughter Card Support:
Port LEDs
No status LEDs are used for analog phone extensions.
· LED1 is used for base card status:
· Red On = Error
· Red Slow Flash = Initializing.
· Red Flash every 5 seconds = Card okay.
· Red Fast Flash = System shutdown.
LED use depends daughter card type fitted.
· LED 9 is used for daughter card status.
· Red On = Error
· Red Slow Flash = Initializing.
· Red Flash every 5 seconds = Card okay.
· Red Fast Flash = System shutdown.
Analog Trunk Daughter Card
· Green on: Card fitted.
· Green flashing: Trunk in use.
PRI Trunk Daughter Card
· Off: No trunk present.
· Green on: Trunk present.
· Green flashing: Trunk in use.
· Red/Green Fast Flash (port 9) or Green Fast Flash (port
10): Alarm indication signal (AIS) from the trunk remote
end.
· Red with Green Blink (port 9) or Green Blink (port 10):
Port in loopback mode (set through IP Office System
Monitor).
Description
IP Office 500 Extension Card Phone 2
IP Office 500 Extension Card Phone 8
System Component Details: Base Cards
analog
phone ports depending on card variant.
1.
SAP Code
700431778
700417231
Page 101
- Issue 1c (09 April 2010)