Etr6 Card - Avaya IP Office Essential Edition Installation Manual

7.3.3 ETR6 Card

This card is used to add 6 ETR phone extension ports to an IP500 V2 control unit. This card is only supported by IP500 V2
systems running in Partner Version mode.
It also includes 2 analog extension ports which are for emergency use only when the card is fitted with an analog trunk
daughter card. A further 4 RJ45 ports (9 to 12) are provided for trunk connections when an IP500 trunk daughter card is
fitted to this card.
Features
ETR Extensions: Ports 1 to 6
Each ETR phone can be used for an ETR or analog phone.
Support for ETR 34D phone is limited to a maximum of 2
per ETR6 card and 4 in total.
· REN 1.
· DTMF dialing only.
· Message waiting indication 51V stepped.
· ICLID mode Bellcore 202.
EF: Ports 7 to 8
· If fitted with an IP500 Trunk Daughter card, during
power failure both these ports are connected to analog
trunk port 12.
· Supports ICLID modes DTMFA, DTMFC, DTMFD, FSK
and UK20.
· REN 2 (1 for external bell device).
· Off-Hook current: 25mA
· Ring Voltage: 40V.
· Intended for connection to two-wire analog phones, the
ports do not include a ringing capacitor. For connection
to 4-wire analog phones, connection should be via a
master socket with ringing capacitors.
Optional Trunk: Ports 9 to 12
Depends on the type of trunk daughter card fitted. The
ETR6 can be fitted with either a
Trunk card.
PARTNER Version Installation Manual
IP Office Essential Edition
· Supports
ETR and analog phones.
· Maximum per IP500 Control Unit: 3.
· IP500 Daughter Card Support:
The IP500 BRI trunk daughter card is not supported.
Analog Trunk card or PRI
System Component Details: Base Cards
Port LEDs
No status LED are used for ETR ports.
· LED1 is used for base card status:
· Red On = Error
· Red Slow Flash = Initializing.
· Red Flash every 5 seconds = Card okay.
· Red Fast Flash = System shutdown.
No status LEDs are used for analog phone extensions.
LED use depends daughter card type fitted.
· LED 9 is used for daughter card status.
· Red On = Error
· Red Slow Flash = Initializing.
· Red Flash every 5 seconds = Card okay.
· Red Fast Flash = System shutdown.
Analog Trunk Daughter Card
· Green on: Card fitted.
· Green flashing: Trunk in use.
PRI Trunk Daughter Card
· Off: No trunk present.
· Green on: Trunk present.
· Green flashing: Trunk in use.
· Red/Green Fast Flash (port 9) or Green Fast Flash (port
10): Alarm indication signal (AIS) from the trunk remote
end.
· Red with Green Blink (port 9) or Green Blink (port 10): Port
in loopback mode (set through IP Office System Monitor).
1.
- Issue 1c (09 April 2010)
Page 103