Attaching Fascia Assembly - Rinnai RIB2310MN Operation & Installation Manual

COMPLETING HEATER INSTALLATION

ATTACHING FASCIA ASSEMBLY

Step 12. Attach the Fascia to the Heater Engine
B
A
Locate and remove the two 8g - 10mm fascia assembly securing screws
tabs on the heater engine body.
B
These screws have been pre-inserted by the manufacturer to ensure correct threading of the
fascia securing tabs.
NOTE
Carefully pick up fascia assembly taking care not to tilt it on it's edge as the glass may slide out of the stand off
posts.
Position the top fold
D
assembly until it is flush at the edges.
Ensure you DO NOT place excessive tension on or pinch the communication cable
manoeuvring the fascia into position.
NOTE
Fit and tighten the two fascia retaining screws
the heater engine body.
The glass dress guard fitted to this appliance reduces the risk of fire and injury and no part of it
should be permanently removed.
NOTE
For protection of young children or the infirm a secondary guard is required.
If the heater is not operating correctly refer to the "TROUBLE SHOOTING CHECKLIST" on page 20
before contacting Rinnai.
It is the responsibility of the installer to check that under normal operating conditions of the
WARNING
appliance, all flue gases are exhausted to the outside atmosphere and that there is no spillage of
combustion gases into the room. Please refer to AS 5601.
During the initial burning in period of approximately 2 hours, some smoke and smell may be
experienced. During this period the heater should be operated on High and the space being
heated should be well ventilated. It may take up to 20 minutes of operation for the logs to achieve
their full flame pattern and glow.
Burner aerations are factory set and can not be adjusted. If you are unable to get the unit to
operate correctly refer to "TROUBLE SHOOTING CHECKLIST" on page 20 before contacting
Rinnai.
Rinnai Australia
Rear View of Fascia
for reference
over the fascia assembly mounting panel
A
F
D
A
A
and gently push the lower edge of the fascia
E
through both the fascia
47
C
pre-positioned in the fascia mounting
and the fascia mounting tabs
F
Sapphire Operation & Installation Manual
E
when
C
on
B