Rinnai RIB2310MN Operation & Installation Manual page 40

HEATER ENGINE INSTALLATION - CONSOLE
Step 4. Attach Spigot Adaptor & Panels To Heater Engine
G1
G2
Assemble the spigot adaptor halves
Drill 4 x Ø 3.2mm holes in the pre pressed location dimples on the top and back of the heater engine, then fit the
flue spigot adaptor
G
Fit the rear panel using 9 - 8g x 10mm self tapping screws (supplied).
H
Before attempting to fit the side
panels it is necessary to elevate the
IMPORTANT
heater engine 100mm off the ground.
Carefully align top panel
screws (supplied) and at the rear using 3 - 8g x 10mm self tapping screws (supplied).
Step 5. Prepare Gas Supply
Remove the threaded brass plug from the S/S flexi pipe consumer gas supply pipe.
Step 6. Fit Heater Engine To Pillar Assembly
The following installation step requires a two man lift. Seek assistance before proceeding further.
WARNING
Carefully lift the heater engine assembly
assembly ensuring that the gas supply pipe and fittings
D
feed into the rear access hole.
E
Align the heater securing holes over the M5 root nuts, then secure using the 4 - M5 x 12mm screws supplied. Note
that two screws are located midway into the appliance on the lower left and right edges, refer to detail
Rinnai Australia
G
H
and
G1
to the heater engine top and rear panels using 4 - 8g x 10mm self tapping screws (supplied).
over tabs of the rear panel
K
L
D
onto the plinth
L
J
, secure together with
G2
Fit side Panels
I
rear panel using 12 - 8g x 10mm self tapping screws
(supplied).
, fasten to the heater at the front using 3 - M5 x 12mm
H
E
Take care that the electrical cord does
not bunch up or get pinched behind the
CAUTION
heater engine.
37
K
I
4 x screws (supplied).
and to heater body at the front and the
J
M
Sapphire Operation & Installation Manual
H
M M
above.
M