Rinnai RIB2310MN Operation & Installation Manual page 41

HEATER ENGINE INSTALLATION - CONSOLE
Step 7. Connect Electrical Supply
Plug in 3 pin connector, if a general purpose outlet (power
point) is used.
Step 8. Connecting Gas
Firmly grasp the S/S flexi pipe
approximately mid way to line up with the gas control valve
inlet then attach pipe to gas control valve and tighten.
N
Step 9. Leak Testing
Turn gas back ON and leak test appliance connection.
Use a soapy solution to test all gas
connections. If a leak is present bubbles will
CAUTION
form at the leak point. When finished remove
any residue with a rag. Prevent any soapy
solution from coming in contact with electrical
components.
Step 10. Completing Heater Installation
Go to "COMPLETING HEATER INSTALLATION" on
page 42.
Rinnai Australia
and bend at 90°
E
38
N E N E
Sapphire Operation & Installation Manual