Rinnai Symmetry RDV3610 Operation Manual
Fireplace
Hide thumbs
Also See for Symmetry RDV3610:
- Operation manual (40 pages) ,
- Installation manual (32 pages) ,
- Maintenance instructions manual (20 pages)
Table of Contents
Advertisement
Operation Manual
Recommended for a new build installation into a false (mock) chimney.
Not suitable for retrofitting into an existing masonry fireplace.
•
Appliance must be installed with a Rinnai supplied flue system.
•
Appliance must be installed, commissioned and serviced by a licensed tradesperson in
accordance with these instructions and all applicable local rules and regulations.
•
Please retain this manual for future reference.
Symmetry RDV3610
Advertisement
Table of Contents
Related Manuals for Rinnai Symmetry RDV3610
Summary of Contents for Rinnai Symmetry RDV3610
- Page 1 Recommended for a new build installation into a false (mock) chimney. Not suitable for retrofitting into an existing masonry fireplace. • Appliance must be installed with a Rinnai supplied flue system. • Appliance must be installed, commissioned and serviced by a licensed tradesperson in accordance with these instructions and all applicable local rules and regulations.
- Page 2 3 below, Rinnai new Zealand Limited supervising gas fitter’s registration number (“Rinnai”) will, at its own discretion, either and the gas fitting certification number. replace or repair any defective product at 4. This warranty commences from the date of no charge to the customer.
-
Page 3: Table Of Contents
Troubleshooting Abnormal flame pattern Optional accessories Commissioning installer details WARNING improper installation, adjustment, alteration, service or maintenance can cause property damage, personal injury or loss of life. For assistance or additional information contact Rinnai on 0800 RINNAI (0800 746 624). -
Page 4: Introduction
Heat your home with four-star efficiency By installing a Rinnai Symmetry RDV3610 you can be confident that you are choosing an incredibly efficient and safe heating source for your home. The Rinnai Symmetry RDV3610 was awarded a four plus star energy rating after vigorous testing by the Australian Gas Association for energy efficiency and safety. -
Page 5: Safety
Do not contact with use power the appliance. boards or double adaptors to operate this appliance. Rinnai new Zealand Limited RDV3610 Operation Manual: 11620-D 04-10... -
Page 6: Installation Process
Electrician installs electrical connection. Standard electrical termination is to the right hand side of the appliance. Gasfitter Installs flue, completes gas connection and completes installation of the Symmetry. Builder Installs cladding. Rinnai new Zealand Limited RDV3610 Operation Manual: 11620-D 04-10... -
Page 7: Clearances
9 mm eterpan MD (medium density) is supplied by PBS Ltd (www.pbs.co.nz). Other materials may also be suitable, please seek advice from a cladding supplier as to the correct application and specification of the material. Rinnai new Zealand Limited RDV3610 Operation Manual: 11620-D... -
Page 8: Mantels, Surrounds, And Hearths
(D) of 100 mm will require 350 mm (C) of side clearance. Hearths A hearth is not necessary but can be used for decorative purposes or protection of sensitive flooring if required. It must not obscure the front of the fire. Rinnai new Zealand Limited RDV3610 Operation Manual: 11620-D 04-10... -
Page 9: General Information
RDV3610 has been framed into a permanent position. The depth of the Symmetry RDV3610 is adjustable to accommodate a range of cladding op- tions. This is important for a frameless installation to achieve a flush finish. Where the edge is visible an aluminium edge can be used to hide the visible cladding. -
Page 10: Maintenance And Servicing
Regular maintenance/servicing is not covered by the Rinnai warranty. Do not attempt to carry out any service work other than that mentioned in the troubleshooting section. if you have any other faults or problems, please refer to your installer or call Rinnai. Safety devices Your Rinnai Symmetry RDV3610 is designed with the following safety devices: •... - Page 11 TV, especially if recessed. the Symmetry RDV3610 has a fan that distributes warm air from the top of the appliance out into the room. As warm air is dispersed outwards as opposed to directly upwards, installation of a tV may be an option.
-
Page 12: Wireless Controller
Symmetry RDV3610 via radio frequency. it needs to be positioned in the same room as the Symmetry RDV3610 and the area that requires heating—a place not subject to temperature fluctuation. For example; if placed... -
Page 13: Operation Of Your Rdv3610
The controller when operating in any of the three modes will automatically shut down and switch the heater off if the room temperature exceeds 40 °C for more than three minutes—this is a safety feature. Rinnai new Zealand Limited RDV3610 Operation Manual: 11620-D 04-10... -
Page 14: Modes Of Operation
(lowest setting), and then default to the last selected flame setting when used again. Flame setting, flame symbol will correspond to flame setting selected. F7-F1 (highest to lowest). Flame mode, nothing will be displayed in this window when operating in flame mode. DOWN Rinnai new Zealand Limited RDV3610 Operation Manual: 11620-D 04-10... -
Page 15: Programming Your Controller
Period 3 5.30 pm 20 °C –– Period 4 11.30 pm °C To revert back to the default settings, press the following sequence of buttons, P > t > t > DOWn. Rinnai new Zealand Limited RDV3610 Operation Manual: 11620-D 04-10... - Page 16 Repeat programming process for remaining periods. If you want to check what has been programmed, press ‘P’ for two seconds and select ‘OK’ continuously to cycle through the settings for each period. Rinnai new Zealand Limited RDV3610 Operation Manual: 11620-D 04-10...
-
Page 17: Operation Using The Controller
LCD display will show ‘CL’ (Code Learn) for two seconds then return to the normal OFF state display. During this time a special code will be transmitted by the RF controller to the Symmetry RDV3610. Turning on and Press the ‘OK’ and ‘PWR’ button at the same time to ignite the heater. This is a safety feature to reduce the chance of young children being able to turn on the unit. -
Page 18: Operation Without The Controller
Under lock out the Power LED will remain illuminated. To start the appliance again, press and release the ON/OFF twice after gas supply resumes. in the event of a power failure the Symmetry RDV3610 will turn off and will need to be manually turned on again when power is restored. This is a safety feature. -
Page 19: Troubleshooting
Turn off gas at meter or LPG cylinder and call installer Small soot deposit on normal operation no action required logs Severe soot deposits Inadequate flue system, incor- Contact a Rinnai Service Centre forming on logs or rect gas pressure or log mis- glass alignment Condensation on glass normal operation... -
Page 20: Abnormal Flame Pattern
Abnormal flame pattern Each Rinnai Flame Fire has a distinct flame pattern. This should look the same every time you start your fire, after an initial warm up period of approximately 20 minutes. Abnormal flame performance and/or pattern can indicate a problem with your fire, such as blocked gas injectors or artificial logs/burn media have shifted from when the fire was first installed. -
Page 21: Optional Accessories
Outer Frames Black integrated mesh, designed to click into place over your fire to Dress Guard protect against touching the hot surface of the glass. Rinnai new Zealand Limited RDV3610 Operation Manual: 11620-D 04-10... - Page 22 Optional accessories Enhance your flame picture with a Rinnai Rockwool pack. The pack Additional burn contains fine ceramic fibres that will emit a beautiful glow to look like media burning embers. Gasfitter required to install as the unit needs to be partially dismantled to install the Rockwool pack.
-
Page 23: Commissioning
Checklist Appliance positioned in a suitable location (clearances, combustible clearances, mantels and surrounds etc.). Rinnai flue system installed and tested to ensure effective draw. Gas pressure checked and set. Burn media installed as per instructions. Appliance tested for correct operation and to ensure no gas leaks. - Page 24 Website: www.rinnai.co.nz All Rinnai appliances meet or exceed the safety standards required by New Zealand gas and electrical regulations. Rinnai is constantly improving its products and as such information and specifications are subject to change or variation without notice.