To Turn Your Heater On With Remote / Thermostatic Control; Modes Of Operation - Rinnai RIB2310MN Operation & Installation Manual

REMOTE / THERMOSTATIC CONTROLLED OPERATION

TO TURN YOUR HEATER ON WITH REMOTE / THERMOSTATIC CONTROL

BEFORE PROCEEDING ENSURE THE GAS AND ELECTRICITY ARE TURNED ON.
Before remote / thermostatic control can be used the heater must be taken out
NOTE
of the OFF/STANDBY condition (supply connected and switched ON but the
heater turned OFF), do this as follows:
Press 'ON'/'OFF' button
be heard.
Step 1. The electronic ignition stops when the pilot flame has been
established. The main burner then ignites off the pilot. Once the main
burner has ignited the heater can the be operated by remote /
thermostatic control.

MODES OF OPERATION

To Turn Remote 'ON' or 'OFF'
11
Step 1. To turn 'ON' - press and release the 'OK' button
display will now include the setting temperature and the mode of operation.
Step 2. To turn 'OFF' - press the 'PWR' button
Manual Temperature Mode
• Temperature can be set at any level.
• Time and day of week does not need to be programmed to operate.
Step 1. With the controller turned 'ON', press and release the 'A/M' button
appears on the LCD.
Step 2. Press press the 'UP' button
increments of 1°C.
Rinnai Australia
once the electronic ignition sparker will be able to
a
STEP 1
UP UP
OK
A/M A/M T T P P PWR
DOWN DOWN
12
STEP 1
UP UP
OK OK
A/M T T P P PWR PWR
DOWN DOWN
13
or 'DOWN' button
10
STEP 2
A/M A/M T T
and 'PWR' button
11
only.
12
STEP 2
UP
OK OK
A/M A/M T T
DOWN
15
to increase or decrease the temperature in
15
15
b
d
UP UP
OK
P P PWR
DOWN DOWN
12
at the same time. The
12
10
P P PWR PWR
until the word 'MANUAL'
13
Sapphire Operation & Installation Manual
a
c