Commissioning The Appliance - Rinnai RIB2310MN Operation & Installation Manual

COMPLETING HEATER INSTALLATION

COMMISSIONING THE APPLIANCE

The gas type codes and gas pressures for this
appliance MUST BE checked and set in
WARNING
accordance with these instructions when the
appliance is
replacement of any component or reassembly
after service.
Step 9. To check and set burner pressures:
1. Refer to the data plate located on the front left panel of
the heater engine for correct gas pressure settings.
2. Using a suitable screw driver loosen the captive
Appliance Test Point Pressure screw (ATPP)
the manometer,
recommended). Refer images for ATPP location.
3. Remove the dust cap
nut and screw
A
4. High Pressure Setting:
Turn the appliance 'ON' and set the heater to the
highest setting, see "TO TURN YOUR HEATER ON" on
page 9. Using an appropriate screw driver hold the low
pressure adjusting screw
the high pressure setting, nut
spanner. Turning the nut clockwise will increase the
outlet pressure whilst turning the nut anti-clockwise will
decrease the outlet pressure.
5. Low Pressure Setting:
Disconnect the power to the Gas Control Valve (GCV)
by separating the connector
(yellow wires). The GCV will automatically default to
'Low Pressure' operation. Using a 10 mm spanner hold
the high pressure adjusting nut
adjusting the low pressure setting, screw
appropriate screw driver. Turning the screw clockwise
will increase the outlet pressure whilst turning the screw
anti-clockwise will decrease the outlet pressure.
6. Replace the dust cap
To ensure the correct operation of the GCV it
is necessary that the dust cap
WARNING
to its original location.
7. Reconnect the power to the GCV by rejoining the
connector (yellow wires).
E
8. After confirming the correct pressures, turn the
appliance 'OFF', remove manometer and tighten the
ATPP sealing screw
9. Turn the appliance 'ON' and 'OFF' a few times to
confirm correct ignition and operation.
10. During the initial burn in period, some smoke and smell
may be emitted. The appliance should be run on the
high setting in a well ventilated room until these
dissipate.
11. Check the flame pattern, see '"ABNORMAL FLAME
PATTERN" on page 48.
Rinnai Australia
installed, OR
(an electronic manometer
from the regulator adjusting
C
.
B
stationary while adjusting
B
with a 10 mm
A
for the power supply
E
stationary while
A
after pressure adjustments.
C
is returned
C
and leak test.
D
after the
GAS
CONTROL
VALVE
LOW PRESSURE
ADJUSTING SCREW
and fit
D
GAS
is
OUTLET
D
APPLIANCE
TEST
POINT
PRESSURE
GAS CONTRL VALVE
POWER CONNECTOR
A
with an
B
ANTICLOCKWISE ANTICLOCKWISE
DECREASE DECREASE
D
APPLIANCE
TEST
POINT
PRESSURE
GAS CONTRL VALVE
POWER CONNECTOR
46
B
HIGH PRESSURE
ADJUSTING NUT
E
CLOCKWISE CLOCKWISE
INCREASE INCREASE
ANTICLOCKWISE ANTICLOCKWISE
DECREASE DECREASE
E
Sapphire Operation & Installation Manual
A
GAS
INLET
INTLET
TEST
POINT
C
CAP
CLOCKWISE CLOCKWISE
B
INCREASE INCREASE
C
CAP