Rinnai RIB2310MN Operation & Installation Manual page 43

HEATER ENGINE INSTALLATION - PLINTH
Step 4. Attach Spigot Adaptor & Panels To Heater Engine
H1
H2
Assemble the the spigot adaptor halves
Drill 4 x Ø 3.2mm holes in the pre pressed location dimples on the top and back of the heater engine, then fit the
flue spigot adaptor
H
Fit the rear panel using 9 - 8g x 10mm self tapping screws (supplied).
I
Fit side Panels and
J
(supplied).
Carefully align top panel
screws (supplied) and at the rear using 3 - 8g x 10mm self tapping screws (supplied).
Step 5. Prepare Gas Supply
Remove the threaded brass plug from the S/S flexi pipe consumer gas supply pipe.
Step 6. Fit Heater Engine To Plinth Assembly
The following installation step requires a two man lift. Seek assistance before proceeding further.
WARNING
Carefully lift the heater engine assembly
assembly ensuring that the gas supply pipe and fittings
E
feed into the rear access hole.
F
Align the heater securing holes over the M5 root nuts, then secure using the 4 - M5 x 12mm screws supplied. Note
that two screws are located midway into the appliance on the lower left and right edges, refer to detail
Rinnai Australia
H
I
and
H1
to the heater engine top and rear panels using 4 - 8g x 10mm self tapping screws (supplied).
to heater body at the front and the rear panel using 12 - 8g x 10mm self tapping screws
K
over tabs of the rear panel
L
M
E
onto the plinth
M
K
J
4 x screws (supplied).
, secure together with
H2
, fasten to the heater at the front using 3 - M5 x 12mm
I
F
Take care that the electrical cord does
not bunch up or get pinched behind the
CAUTION
heater engine.
40
L
N
N
Sapphire Operation & Installation Manual
I
N
above.
N