Rinnai RIB2310MN Operation & Installation Manual page 47

COMPLETING HEATER INSTALLATION
Confirm the correct location of all the logs before
proceeding with the placement of the granular burner
medium, ensuring that all the logs are firmly seated in
their correct positions and that the ports of the main
burner are clean and clear of any debris that may have
been shed during the log installation.
Step 4. Replacing the Burner Box Glass
Replace burner box glass panel assembly in reverse sequence as instructed in Step 2. page 42.
Step 5. Unpack the Fascia Assembly & Inner Frame
The Fascia Assembly and the Inner Frame are supplied in a separate carton, check to ensure you have all the
contents as listed on "CARTON CONTENTS / ITEM CHECKLIST" on page 1 at the start of this manual before
proceeding. Remove all packaging materials and check all components for damage. If ANY damage is evident DO
NOT install or operate this appliance. Contact your supplier for advice.
When placing the facia assembly down ensure it is placed on its lower edge or flat. If it is placed
on its left or right edge the glass may slide out of the stand off posts. If this should occur ensure
NOTE
that the silicon rubber mounts are not dislodged when sliding the glass back into position.
Step 6. Fitting the Inner Frame
A
The inner frame is packed with the Fascia and can now be fitted to the heater engine. The inner frame is held
A
in position by return tabs
Fit the inner frame
A
gently swing down the bottom edge
Rinnai Australia
B
D
E
on the top edge and by magnets
B
to the heater engine by locating the over-folded edge
onto the magnets
D
COVERING PORTS
For best flame effect carefully place the granular
burner medium over and around the front burner ports.
It is desirable that the gas jet is diffused by the
granules, this will reduce any 'candling' effect of the
flame enhancing the realistic log burning look of the
heater.
DO NOT force any granular material into the burner
ports or completely block any of the burner ports.
on the bottom edge.
C
B
.
E
44
C
A
over the two return tabs
Sapphire Operation & Installation Manual
then
C