Table of Contents
Advertisement
Attaching the flexi flues to the spigot plate
The flexi flues need to be securely fixed to the engine spigot plate using the clamps provided,
and the clamps need to be screwed in place. To do this the spigot plate needs to be temporarily
removed from the engine—undo the two front screws holding it in place.
1. Stretch the flexi flues, ensuring the section that fits onto the spigot is completely extended.
2. Place the flue clamps over the flexi flues and tighten. DO NOT overtighten as this will crush and
damage the flue.
3. Drill through the pre-punched holes, either side of the flue clamp, and into the
flexi flue spigot. Secure in place using the stainless steel self-tapping screws
provided, ensuring the connection will stop movement or dislodgement of the
flue.
Helpful tip
Once the flue is connected to the spigot plate it will be free-hanging. To avoid damage to the flue
it's best to support this within the cavity while waiting to install the engine.
Flue clamp
screwed in place
through pre-
punched holes
Tabs to hold the
plate in place
Flue guide either
side of the rail
Ember Installation Guide: 12890-F 06-21 | 19
Advertisement
Table of Contents
