Remote / Thermostatic Controlled Operation; Remote Controller - Battery Installation - Rinnai RIB2310MN Operation & Installation Manual

REMOTE / THERMOSTATIC CONTROLLED OPERATION

For further enhanced comfort and convenience the Sapphire heater can be both remotely and thermostatically
controlled through the use of a wireless wall mountable controller / thermostat.
The wireless controller / thermostat is an optional extra available through your Rinnai stockist.
DISPLAY LAYOUT & FEATURES
3
4
2
8
UP
OK
A/M T P PWR
DOWN
BUTTON LAYOUT & FEATURES
11
UP
OK
A/M T P PWR
13
DOWN
14
15

REMOTE CONTROLLER - BATTERY INSTALLATION

Carefully remove the battery compartment cover panel from the rear of your controller hand-set and
insert the two AA batteries supplied ensuring that '+' and '-' polarity is correct. After installing the
batteries your remote control will display an 'Initial Set-up Screen' with the current room temperature
in °C, a default time setting of
When batteries are changed all settings other than synchronisation are lost and the
controller will revert back to the 'Initial set -up screen'.
NOTE
Rinnai Australia
Time of day with 'AM' or
1
5
'PM' display
Day of the week
2
6
Current Room temperature
17 3
display
Setting Temperature with
4
'SET' display
Transmit indicator
5
1
7
Battery Low indicator
6
9
Automatic mode indicator
7
Program mode indicator
8
Manual mode indicator
9
Setting 'UP' Button
10
'OK' Button
11
'PWR' (Power) Button
12
'A/M' Button
13
'T' (Time) Button
14
Setting 'DOWN' Button
15
10
'P' (Program) Button
16
12
Flame Indicator
17
16
and the default day of the week set to 'MO' - Monday.
Displays time of the day in hours and minutes, 'AM' or 'PM'.
The time is displayed when the thermostat is 'ON' or 'OFF'.
Displays the current day of the week.
The day is displayed when the thermostat is 'ON' or 'OFF'.
Displays the current temperature.
The temperature range is 7°C - 32°C.
When the thermostat is 'ON', the programmed (set)
temperature will be displayed.
Indicates that the thermostat is transmitting to the receiver,
the symbol will appear on the LCD for 1 sec.
Indicates when the battery power is below an acceptable
level.
Indicates if the thermostat is in automatic mode.
Indicates that the thermostat is in programming mode.
Indicates if the thermostat is in manual mode.
Increase hours, minutes, day or temperature.
Accepts the current function and advances to the next
function.
Switches the thermostat 'ON' and 'OFF'. To turn 'ON' press
and release the 'PWR' and 'OK' Buttons at the same time
this will turn the thermostat 'ON' to the most recently
programmed working mode.
Toggles between automatic, manual and flame mode.
Initiates time and day of the week programming (must press
and hold for 2 or more seconds when the thermostat is
'OFF').
Decrease hours, minutes, day or temperature.
Initiates the programming mode (must press and hold for 2 or
more seconds when the thermostat is 'OFF').
Indicates the flame setting.
The Flame symbol graphically indicates which of the 7
graduated settings between Low and High flame when the
burner is on.
In AUTO or MANUAL temperature mode, if the burner is OFF
due to room temperature being reached the symbol will
modulate UP and DOWN. This is to indicate that the unit is
still ON even though there are no flames visible in the
appliance.
10 Sapphire Operation & Installation Manual