Rinnai RIB2310MN Operation & Installation Manual page 46

COMPLETING HEATER INSTALLATION
Step 3. Installing the Log Set and Burner Granules
For clarity the drawings are displayed without showing the entire heater.
DO NOT remove the burner from heater engine to install the log set.
NOTE
Use extreme care when handling the Log Set components, they are made from a very fragile high
temperature material and will damage if handled roughly. Only remove the components from
their packaging as required.
Check to ensure that the ports of the main burner
are clean and clear of any particles and all packaging
material. The log set MUST BE installed in the precise
order as stated.
Log . Select the thick straight log and fit onto the
2
sheet metal locators at base of the left side and rear
panels. When correctly located this log will be touching
the burner box walls.
Log . Select the longest log and fit onto the sheet
4
metal locators at base of the right side and rear panels.
When correctly located this log will be touching the
burner box walls and be lightly resting on log
Rinnai Australia
2
1
4
1
Log . Select the thicker 'Y' shaped log and fit into
1
position by lining up two pin holes onto the two pins of
the locating bracket that is fixed to the centre of the
main burner.
Log . Select the thinner 'Y' shaped log and fit into
3
position by lining up two pin holes onto the two pins of
the first two logs. Ensure this log is seated all the way
down until it touches logs
Log . Locate the final bowed log onto the sheet
5
metal locator at the base of the right side panel and the
bracket fixed to the main burner, lean the log back until
. it rests on piece number
1
43
1
3
1
2
and .
1 2
5
4
.
4
Sapphire Operation & Installation Manual