Replace The Glass Panel Assembly; Connect To Electricity Supply - Rinnai RDV3610ETR Operation Manual

Piece 2. Long curved log.
Location on the front left bottom edge
and the rear end bottom edge into the
burner body recess.
Piece 3. Stocky chipped log.
Location is flat on the rear bottom edge
into the burner and nestles on the top of
'Piece 1'.
Piece 4. Branching Segment.
Nestles in 'U' shaped groove with a
keyed section into the burner, the front
rests on 'Piece 2'
Piece 5. Bowed log.
Right and left ends locates in recesses
in pieces 2 & 3 consecutively. The
middle of this piece has a 'knot' which
has point contact with the tip of 'Piece1'.
Piece 6 & 7.Stones.
The stones are to be placed over the
burner assembly visible at left and right
of the burner pad. One over each hole.
Final layout.
Complete.
Step 8. REPLACE THE GLASS PANEL ASSEMBLY
Replace glass panel assembly in reverse sequence as instructed in Step 3 - (3)' as detailed page 26.
THE GAS TYPE CODES AND GAS PRESSURES FOR THIS APPLIANCE MUST BE
CHECKED AND SET IN ACCORDANCE WITH THESE INSTRUCTIONS WHEN THE
WARNING
APPLIANCE IS INSTALLED, OR AFTER THE REPLACEMENT OF ANY COMPONENT
OR REASSEMBLY AFTER SERVICE.
Step 9. CONNECT TO ELECTRICITY SUPPLY
See page 21 for details.
Rinnai Australia
HEATER INSTALLATION
30 Installation Manual