Rinnai RIB2310MN Operation & Installation Manual page 17

REMOTE / THERMOSTATIC CONTROLLED OPERATION
Additional information about Remote Thermostat Control Operation
Character Diagnostic Check. To check the display characters on the remote control turn the controller 'off' by
pressing the 'PWR' button then press P - T - T - OK in rapid succession.
A/M A/M
The remote will then commence automatically cycling through all the display characters, finally displaying the full
screen as shown below.
This process takes approximately 20 seconds and does not affect any programming.
If any of the characters are not displayed contact your Rinnai stockist for a replacement controller.
The Fan and Snowflake symbols displayed are not utilized in the operation of the Sapphire heater.
NOTE
Rinnai Australia
UP UP
OK OK
T T P P PWR
DOWN DOWN
A/M T
UP UP
OK
A/M A/M T
DOWN DOWN
1
2
3
UP
OK
P PWR
DOWN
14
P PWR PWR
Sapphire Operation & Installation Manual