Rinnai RIB2310MN Operation & Installation Manual page 19

REMOTE / THERMOSTATIC CONTROLLED OPERATION
Automatic Timer Mode
• In automatic timer mode temperature is regulated to the programmed level and time.
• Time and day of week MUST BE set
Step 1. With the controller turned 'ON', press and release the 'A/M' button
on the LCD.
Step 2. At any time press the 'UP' button
increments of 1°C.
Flame Mode
• Temperature control is over ridden and the flame size can be set to any setting from F7 highest to F1 lowest.
When the fire first ignites it remains on highest flame for the first 60 seconds before changing to
the selected flame height.
NOTE
• Time and day of week does not need to be programmed.
Step 1. With the controller turned 'ON', press and release the 'A/M' button
and the flame symbol
Step 2. Press the 'UP' button
The fan speed automatically adjusts to the corresponding flame height. It is not able to be selected
by the operator. See the flame table below for flame height to fan speed relationship.
NOTE
Flame Height
Manually Overriding The Set Program
At any time, the temperature or fan speed may be adjusted 'UP' or 'DOWN' similarly to operating in "Manual
Temperature Mode" on page 15.
However, whenever the thermostat changes to a new time period, the temperature will be set
automatically according to that period's setting.
NOTE
Rinnai Australia
.
STEP 1
UP UP
OK OK
A/M T T P P PWR PWR
DOWN DOWN
13
10
STEP 1
UP UP
OK OK
A/M T T P P PWR PWR
DOWN DOWN
13
appear on the LCD panel.
17
10 or 'DOWN' button
1
Fan Speed HIGH
STEP 2
OK OK
A/M A/M T T
DOWN
15
or 'DOWN' button 15 to increase or decrease the temperature in
STEP 2
17
OK OK
A/M A/M T T
DOWN
15
15 to increase or decrease the flame height.
2 3
LOW LOW LOW
16
10
UP
P P PWR PWR
until the word 'AUTO' appears
13
17
10
UP
P P PWR PWR
until the letter 'F' with a number
13
4 5 6
HIGH HIGH
Sapphire Operation & Installation Manual
7
HIGH