Remote Control Operation; Remote Control Activation; Button Functions, Display & Operation; Lost, Misplaced Or Broken Remote Control - Rinnai 650 Operation Manual

REMOTE CONTROL OPERATION

REMOTE CONTROL ACTIVATION

The remote is supplied with two Lithium cell CR2450 button batteries
already pre-inserted.
To activate pull the clear tab
on the digital display
I
Noting that this also occurs when ever a fresh set of batteries is installed.
Remove the batteries if the remote is not going to be used
for a long time. This will help avoid damage from leaking
batteries. If leakage has occurred the remote will need to
NOTE
be replaced as leaking chemicals could be a risk if touched
or ingested.
When the controller buttons are pressed the green indicator located in
the IR receiver window
that control inputs are being received, this indicates your remote control
is now working.
BUTTON FUNCTIONS, DISPLAY & OPERATION
For the remote control to be able to function, the appliance
Standby / ON button
Using the remote control to turn OFF the heater will place
NOTE
the heater into STANDBY mode.
The Standby / ON button
and ON modes.
The UP / DOWN buttons
output in five adjustment levels in fixed combination with two fan speeds.
The relationship between flame levels and fan speeds is factory pre-set
and therefore cannot be adjusted, and are as follows:
Flame Level 1
Fan Speed Low
On initial start-up the appliance default flame height setting is 5 - High. The flame height may only
be adjusted after at least 30 seconds of operation.
NOTE
The remote control temperature sensor
temperature of where the remote control is currently located.
The remote controls digital display
the remote control is located in. It has a motion activated back light which will remain illuminated
for approximately 5 seconds after a movement is sensed or when a button is pressed. Frequent
illumination of the back light greatly reduces the remote control's operational battery life. To
increase battery life, ensure that unnecessary illumination of the display is avoided.

LOST, MISPLACED OR BROKEN REMOTE CONTROL

Breakage of the plastic housing could expose sharp edges, replace the remote if this occurs.
Avoid getting the remote wet as water entry will damage the remote.
NOTE
In the event of a lost, misplaced or broken remote control the appliance may still be operated in a limited capacity.
By using the power ON/OFF button, located in the manual control panel, on the front of the heater at the lower
right hand corner.
In the event that the remote control operation is not available, this appliance may then still be
operated in a limited capacity by using the heater's control panel.
NOTE
Refer to "Control Panel Operation" on page 9 for details on how to use the appliance in this
mode and the limitations of this form of operation.
Rinnai
, noting that 0X (OK) will briefly be shown
K
, to confirm that the activation was successful.
will flash and 'Beeps' will be emitted to confirm
B
must be in the "ON" condition.
A
switches the heater between the Standby
G
control the height of the flame and heat
H
2 3
Low High
I
4 5
High High
(located on the base of the controller) reads the
J
shows the temperature (in degrees Celsius) of the room that
10
A
B
G
H
I
J
RDV 600_700ER OM
K