Remote Control Operation; Batteries And Activating The Remote Control; Button Functions, Display & Operation - Rinnai 650 Operation & Installation Manual

For the remote control to be able to function, the appliance ON/OFF button
position. Using the remote control to turn off the heater will place the heater into STANDBY mode,
IMPORTANT
when in this mode the Red Power Indicator
y WARNING KEEP BATTERIES OUT OF REACH OF CHILDREN.
y
Swallowing may lead to serious injury in as little as 2 hours or death, due to chemical burns
and potential perforation of the oesophagus.
y
If you suspect your child has swallowed or inserted a button battery immediately call the
24-hour Poisons Information Centre on 13 11 26 for fast, expert advice.
y
Examine devices and make sure the battery compartment is correctly secured, e.g.
that the screws or other mechanical fasteners are tight. DO NOT use if compartment is not secure.
y
Dispose of used button batteries immediately and safely. Flat batteries can still be dangerous and may be a choking hazard.
y
Inform others about the risk associated with button batteries and how to keep their children safe.
y
Remove the batteries if the remote is not going to be use for prolonged periods. This will help prevent damage from leaking
batteries. If leakage has occurred and corrosion is evident the remote will need to be replaced.
y
Leaking chemicals are toxic and MUST NOT be touched or ingested.
y
NEVER mix old and new batteries.
y
DO NOT immerse the remote control in any liquid, this will damage the remote control, rendering it inoperable and voiding
its warranty.

BATTERIES AND ACTIVATING THE REMOTE CONTROL

• 2 x Button Batteries are supplied with the remote control.
• Remove the plastic tab to activate.
• This remote control uses 2 x Lithium CR2450 or equivalent batteries.
• The appliance will flash and emit 'Beeps' to confirm the setting has been received from the remote control unit;
this indicates your remote control is now working.
BUTTON FUNCTIONS, DISPLAY & OPERATION
This remote control selects flame height and fan
speed in five levels
The STANDBY / ON button
between the STANDBY and ON modes.
Flame height may only be adjusted after at least
30 seconds of operation.
The UP / DOWN buttons
flame and heat output.
The relationship between flame height and fan speed
is factory preset and cannot be adjusted, there are
five flame / fan settings as listed below.
Flame Height
Fan Speed
(2 speed only)
On initial start-up the appliance default
flame height setting is setting 5 - High.
NOTE Use the UP / DOWN buttons
the height of the flame and the heat
output.
The room temperature display
temperature in degrees Celsius where the control is
currently located and is updated once a minute. The
temperature sensor is located at the base of the
control. During normal operation the display will
remain illuminated for approximately 5 seconds after
a button has been pushed, constant activation will
greatly reduce battery life. Avoid unnecessary
activation.
Rinnai

REMOTE CONTROL OPERATION

switches the heater
c
control the height of the
d
1 2 3 4
Low Low Low High High
to control
d
displays the room
e
will be on. This is normal.
b
5
c
d
8
e
13
must be in the "ON"
a
1 b a
RDV 600_700 OIM