Table of Contents
Advertisement
REMOTE CONTROL OPERATION
REMOTE CONTROL ACTIVATION
The remote is supplied with two Lithium cell CR2450 button batteries
already pre-inserted.
To activate pull the clear tab
on the digital display
I
Noting that this also occurs when ever a fresh set of batteries is installed.
Remove the batteries if the remote is not going to be used
for a long time. This will help avoid damage from leaking
batteries. If leakage has occurred the remote will need to
NOTE
be replaced as leaking chemicals could be a risk if touched
or ingested.
When the controller buttons are pressed the green indicator located in
the IR receiver window
that control inputs are being received, this indicates your remote control
is now working.
BUTTON FUNCTIONS, DISPLAY & OPERATION
For the remote control to be able to function, the appliance
Standby / ON button
the remote control to turn OFF the heater will place the
NOTE
heater into STANDBY mode.
The Standby / ON button
and ON modes.
The UP / DOWN buttons
output in five adjustment levels in combination with two fan speeds.
The relationship between flame levels and fan speeds is factory pre-set
and therefore cannot be adjusted, and are as follows:
Flame Level
1
Fan Speed
Low
On initial start-up the appliance default flame height setting is setting 5 - High and the flame
height may only be adjusted after at least 30 seconds of operation.
NOTE
The remote control temperature sensor
temperature of where the remote control is currently located.
The remote controls digital display
the remote control is located in. It has a motion activated back light which will remain illuminated
for approximately 5 seconds after a movement is sensed or when a button is pressed. Frequent
illumination of the back light greatly reduces the remote controls operational battery life, ensure
that unnecessary illumination of the display is avoided.
LOST, MISPLACED OR BROKEN REMOTE CONTROL
Breakage of the plastic housing could expose sharp edges, replace the remote if this occurs.
Avoid getting the remote wet as water entry will damage the remote.
NOTE
In the event of a lost, misplaced or broken remote control, full operational control of the heater is still possible by
use of the Wi-Fi App.
In the event that both the remote control and network based operation are not available, this
appliance may then still be operated in a limited capacity by using the heater's control panel.
NOTE
Refer to "Control Panel Operation" on page 9 for details on how to use the appliance in this
mode and the limitations of this form of operation.
Rinnai
, noting that 0X (OK) will briefly be shown
K
, to confirm that the activation was successful.
will flash and 'Beeps' will be emitted to confirm
B
must be in the "ON" position. Using
A
switches the heater between the Standby
G
control the height of the flame and heat
H
2
3
Low
High
I
4
5
High
High
(located on the base of the controller) reads the
J
shows the temperature (in degrees Celsius) of the room that
10
A
B
G
H
I
J
RHFE0800_1000_1500 OM
K
Advertisement
Table of Contents
