Concluding Steps - Fujitsu PRIMERGY TX1320 M1 Upgrade And Maintenance Manual

Figure 92: Cabling of the FBU
Ê Run the FBU adapter cable through the middle cable bracket as shown (see
circle) (1).
Ê Connect the FBU adapter cable to the TFM module on the SAS RAID
controller D3116 (2).
9.3.1.6

Concluding steps

Perform the following procedures to complete the task:
Ê Close the front cage as described in section
page 62.
Ê Close the server cover as described in section
page 64.
Ê Reconnect the AC power cord to the power supply unit.
Ê If applicable, update the firmware of the RAID controller that has been
connected to the FBU as described in section
firmware" on page
Ê Enable boot watchdog functionality as described in section
boot watchdog functionality" on page
TX1320 M1
87.
Upgrade and Maintenance Manual
Expansion cards and backup units
"Closing the front cage" on
"Closing the server" on
"Updating RAID controller
92.
"Enabling SVOM
191