Removing An Expansion Card; Installing An Expansion Card; Connecting Cables To The Expansion Card; Concluding Steps - Fujitsu PRIMERGY TX1320 M1 Upgrade And Maintenance Manual

Expansion cards and backup units
9.2.3.2

Removing an expansion card

Ê If applicable, remove SFP+ transceiver modules from the expansion card to
be removed, as described in section
on page 214.
Ê Remove the defective expansion card as described in section
expansion cards" on page
9.2.3.3

Installing an expansion card

Ê Install the new expansion card as described in section
cards" on page
Ê If applicable, reinstall SFP+ transceiver modules on the replacement
expansion card, as described in section
modules" on page
9.2.3.4

Connecting cables to the expansion card

Ê If applicable, connect internal cables to the expansion card.
I
For a complete cabling overview, please refer to section
page 319.
9.2.3.5

Concluding steps

Perform the following procedures to complete the task:
Ê Close the server cover as described in section
page 64.
Ê If applicable, connect external cables to the expansion card.
Ê Reconnect the AC power cord to the power supply unit.
Ê After installing or replacing a Modular RAID controller, update the firmware
as described in section
Ê Enable boot watchdog functionality as described in section
boot watchdog functionality" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
182
178.
174.
207.
"Updating RAID controller firmware" on page
99.
Upgrade and Maintenance Manual
"Replacing SFP+ transceiver modules"
"Installing SFP+ transceiver
"Closing the server" on
92.
"Removing
"Installing expansion
"Cabling" on
87.
"Enabling SVOM
"Enabling
TX1320 M1