Fujitsu PRIMERGY TX1320 M1 Upgrade And Maintenance Manual page 308

System board and components
Figure 188: Removing the system board
Ê Hold the defective system board by the memory module ejectors and a PCI
slot and at a slight angle lift it out of the chassis.
Ê If applicable, remove the TPM as described in
on page 298.
Figure 189: Removing the power cable clamp
Ê Using a small pair of combination pliers, press together the hooks on the
power cable clamp (1) and remove it from the defective system board (2).
308 Upgrade and Maintenance Manual
section "Removing the TPM"
TX1320 M1