Label Gone Timeout - Datalogic QuickScan Lite QW2100 Product Reference Manual

ENTER/EXIT PROGRAMMING MODE

Label Gone Timeout

This feature sets the time after the last label segment is seen before the reader prepares for a new
label. The timeout can be set within a range of 10 milliseconds to 2,550 milliseconds (2.55 sec-
onds) in 10ms increments. Label Gone Timeout does not apply to scan modes that require a
trigger pull for each label that is read. See
gramming instructions.
$CSNLG
Select Label Gone Timeout Setting
Make a mistake? Scan the CANCEL bar code to abort and not
save the entry string. You can then start again at the beginning.
Product Reference Guide
016 = Timeout of 160 ms
DEFAULT
Label Gone Timeout on page 244
~
CANCEL
Label Gone Timeout
for more detailed pro-
19