Enter/Exit Programming Mode
Label Gone Timeout
This feature sets the time after the last label segment is seen before the reader
prepares for a new label. The timeout can be set within a range of 10 millisec-
onds to 2,550 milliseconds (2.55 seconds) in 10ms increments. Label Gone
Timeout does not apply to scan modes that require a trigger pull for each label
that is read. See
ming instructions.
$CSNLG
Select Label Gone Timeout Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
72
"Label Gone Timeout"
10 = Timeout of 160 ms
DEFAULT
on page 297 for more detailed program-
~
CANCEL
QuickScan™ I QM21X1 / QBT21X1
Label Gone Timeout