Software Version Transmission; Resetting The Product Configuration To Defaults - Datalogic QuickScan Lite QW2100 Product Reference Manual

Getting Started

Software Version Transmission

The software version of the device can be transmitted over the RS-232 and Keyboard in-
terfaces by scanning the following label.

Resetting the Product Configuration to Defaults

If you aren't sure what programming options are in your reader, or you've changed some
options and want to restore the Custom Default Configuration that may have been saved
in the reader, scan the
restore the custom configuration for the currently active interface.
Resetting the Product Configuration to Defaults — cont.
If you aren't sure what programming options are in your reader, or you've changed some
options and want to restore the Factory Configuration, you have two options. You can
scan the
figuration
tings including the interface type. The USA label restores Label IDs to those historically
used in the USA. The EU label restores Label IDs to those historically used in Europe.
The Label ID sets for USA and EU are shown in the Label ID section of this manual.
The programming section lists the factory default settings for each of the menu com-
mands (indicated by shaded blocks and bold text) on the following pages.
10
Restore Custom Default Configuration
Custom defaults are based on the interface type. Configure the
reader for the correct interface before scanning this label.
NOTE
Restore Custom Default Configuration
Restore USA Factory Configuration
bar code below. Both labels restore the reader configuration to the factory set-
Restore USA Factory Configuration
Restore EU Factory Configuration
Transmit Software Version
bar code or the
bar code below. This will
Restore EU Factory Con-
QuickScan Lite QW2100
TM