Disable Character - Datalogic QuickScan Lite QW2100 Product Reference Manual

Disable Character

Specifies the value of the RS-232 host command used to disable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected.
To set the value:
1. Determine the desired character or value. A setting of 0xFF indicates the the Disable
2. Use the
3. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Programming
4. Scan the bar code: SELECT DISABLE CHARACTER SETTING.
5. Scan the appropriate two alpha-numeric characters from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming
This completes the procedure. See
Table 12. Disable Character Setting Examples
STEP ACTION
1 Desired character/value
2 Hex equivalent
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT DISABLE CHARACTER VALUE SETTING
Scan Two Characters From
5
Appendix E, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
Setting to previously defined characters such as XON, XOFF, or host
commands conflicts with normal operation of these characters. 8-bit
data is not recognized when the option
Data Bits.
NOTE
Character is not used (not available).
ASCII Chart on the inside back cover of this manual to find the hex equivalent
for the desired character/value.
Mode.
Keypad, that represent the desired character/value in step
will cause a two-beep indication.
Mode.
'd'
0x64
'6' and '4'
Table 12 for some examples of how to set this feature.
EXAMPLES
'}'
0x7D
'7' and 'D'
Disable Character
Data Bits
has been set as 7
Appendix E,
1 above. The second character
Disable Command
'D'
Not Used
0x44 0xFF
'4' and '4' 'F' AND 'F'
255