Enable Character - Datalogic QuickScan Lite QW2100 Product Reference Manual

References

Enable Character

Specifies the value of the RS-232 host command used to enable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected.
To set this feature:
Determine the desired character or value. A setting of 0xFF indicates the the Enable Character is
not used (not available).
1. Determine the desired character or value.
2. Use the
3. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Programming
4. Scan the bar code: SELECT ENABLE CHARACTER SETTING.
5. Scan the appropriate two alpha-numeric characters from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming
This completes the procedure. See
Table 13. Enable Character Setting Examples
STEP ACTION
1 Desired character/value
2 Hex equivalent
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT ENABLE CHARACTER VALUE SETTING
Scan Two Characters From
5
Appendix E, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
256
Setting to previously defined characters such as XON, XOFF, or host
commands conflicts with normal operation of these characters. 8-bit
data is not recognized when the option
Data Bits.
NOTE
ASCII Chart on the inside back cover of this manual to find the hex equivalent
for the desired character/value.
Mode.
Keypad, that represent the desired character/value in step
will cause a two-beep indication.
Mode.
'e'
0x65
'6' and '5'
Table 13 for some examples of how to set this feature.
EXAMPLES
'}'
0x7D
'7' and 'D'
Data Bits
has been set as 7
Appendix E,
2 above. The second character
Enable Command
'E'
Not Used
0x45 0xFF
'4' and '5' 'F' AND 'F'
TM
QuickScan Lite QW2100