RS-232/USB-Com Interfaces
Intercharacter Delay
This parameter specifies the intercharacter delay between the end of one character and the
beginning of the next. The delay can be set within a range of zero (0) to 990 milliseconds in
10ms increments. A setting of zero specifies no delay. See
for more detailed programming instructions.
$CR2IC
Select Intercharacter Delay Setting
Make a mistake? Scan the CANCEL bar code to abort and not
save the entry string. You can then start again at the beginning.
44
00 = No Intercharacter Delay
DEFAULT
ENTER/EXIT PROGRAMMING MODE
Intercharacter Delay on page 250
$CR2IC00
Intercharacter Delay = No Delay
~
CANCEL
QuickScan
Lite QW2100
TM