Label Gone Timeout - Datalogic Heron HD3100 Product Reference Manual

Enter/Exit Programming Mode

Label Gone Timeout

This feature sets the time after the last label segment is seen before the scan-
ner prepares for a new label. The timeout can be set within a range of 10 milli-
seconds to 2,550 milliseconds (2.55 seconds) in 10ms increments. Label Gone
Timeout does not apply to scan modes that require a trigger pull for each label
that is read. See
ming instructions.
$CSNLG
Select Label Gone Timeout Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
DEFAULT
64
"Label Gone Timeout" on page 237
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
representing your desired character(s). End by scanning
the ENTER/EXIT bar code again.
for more detailed program-
Appendix D, Keypad
~
CANCEL
016 = Timeout of 160 ms
Label Gone Timeout
Heron™ HD3130