Led And Beeper Indications - Datalogic QuickScan Lite QW2100 Product Reference Manual

LED and Beeper Indications

INDICATION
The reader is in the process of pow-
Power-up Beep
ering-up.
A label has been successfully
Good Read Beep
scanned by the reader.
There is an error in the reader's soft-
ROM Failure
ware/programming
Indicates that a host connection is
Limited Scanning
not established when the USB inter-
Label Read
face is enabled.
Reader Active The reader is active and ready to
Mode scan.
Reader The reader has been disabled by
Disabled the host.
While in Stand Mode or Trigger
Green Spot is on Object Sense mode the green spot
continuously shall be on while in stand watch
state.
Upon successful read of a label, the
a
Green Spot
software shall turn the green spot on
flashes momen-
for the time specified by the config-
tarily
ured value.
Programming Mode - The following indications ONLY occur when the reader is in Programming Mode.
Label Programming A valid programming label has been
Mode Entry scanned.
Label Programming
Mode Rejection of A label has been rejected.
Label
In cases where multiple labels must
Label Programming be scanned to program one feature,
Mode Acceptance this indication acknowledges each
of Partial Label portion as it is successfully
scanned.
Configuration option(s) have been
Label Programming
successfully programmed via labels
Mode Acceptance
and the reader has exited Program-
of Programming
ming Mode.
Label Programming
Mode Cancel Item Cancel label has been scanned.
Entry
a.
Except when in sleep mode or when a
290
DESCRIPTION
Good Read LED Duration
LED
LED behavior for this indica-
tion is configurable via the
feature "Good Read: When to
Indicate"
Flashes
N/A
a
The LED is lit steadily
The LED blinks continuously
N/A
N/A
LED blinks continuously
N/A
N/A
N/A
N/A
other than 00 is selected
BEEPER
Reader beeps four times at highest
frequency and volume upon power-
up.
The reader will beep once at current
frequency, volume, mono/bi-tonal
setting and duration upon a suc-
cessful label scan.
Reader sounds one error beep at
highest volume.
Reader 'chirps' six times at the
highest frequency and current vol-
ume.
N/A
N/A
N/A
N/A
Reader sounds four low frequency
beeps.
Reader sounds three times at low-
est frequency & current volume.
Reader sounds one short beep at
highest frequency & current volume.
Reader sounds one high frequency
beep and 4 low frequency beeps
followed by reset beeps.
Reader sounds two times at low fre-
quency and current volume.
QuickScan Lite QW2100
TM