Set Length 2 - Datalogic QuickScan Lite QW2100 Product Reference Manual

Set Length 2

This feature specifies one of the bar code lengths for a given symbology. Length 2 is the maxi-
mum label length if in Variable Length Mode, or the second fixed length if in Fixed Length
Mode. Length includes the bar code's data characters only.
Reference the
symbology being set.. A setting of 00 specifies to ignore this length (only one fixed length).
Follow these instructions to set this feature:
1. Determine the desired character length. Pad the number with leading zeroes to yield two
2. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Programming
3. Scan the "Select Length 2 Setting" for the symbology being set.
4. Scan the appropriate two digits from the keypad in
5. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming
This completes the procedure. See
Table 20. Length 2 Setting Examples
STEP ACTION
1 Desired Setting
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SELECT LENGTH 2 SETTING
Scan Two Characters From
4
Appendix E, Keypad
5 Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
Symbologies section to view the selectable range (number of characters) for the
digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
Mode.
the length setting which was determined in the steps above. You will hear a two-beep indi-
cation after the last character.
If you make a mistake before the last character, scan the CANCEL bar code
to abort and not save the entry string. You can then start again at the begin-
ning.
NOTE
Mode.
00 (ignore second
length)
'0' and '0'
Appendix E,
Table 20 for some examples of how to set this feature.
EXAMPLES
07 Characters 52 Characters
'0' and '7'
Set Length 2
Keypad, that represent
74 Characters
'5' and '2' '7' and '4'
269