Indicate Transmission Failure; Disable Character - Datalogic QuickScan Lite QW2100 Product Reference Manual

ENTER/EXIT PROGRAMMING MODE

Indicate Transmission Failure

This option enables/disables the reader's ability to sound an error beep to indicate a transmission
failure while in ACK/NAK mode.
$CR2TF01
Indicate Transmission Failure = Enable Indication

Disable Character

Specifies the value of the RS-232 host command used to disable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected. See
page 255
$CR2DC
Select Disable Character Setting
Product Reference Guide

for more detailed programming instructions.
Setting to previously defined characters such as XON, XOFF, or host
commands conflicts with normal operation of these characters. 8-bit
data is not recognized when the option
Data Bits.
NOTE
0x44 = Disable Character is 'D'
DEFAULT
Indicate Transmission Failure
$CR2TF00
Indicate Transmission Failure = Disable Indication
DEFAULT
Disable Character on
Data Bits

has been set as 7
51