Ack Character - Datalogic QuickScan Lite QW2100 Product Reference Manual

ACK Character

This setting specifies an ASCII character or hex value to be used as the ACK character. ASCII
characters or any hex value from 0 to 0xFF can be selected.
To set this feature:
1. Determine the desired character or value.
2. Use the
3. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Programming
4. Scan the bar code: SELECT ACK CHARACTER SETTING.
5. Scan the appropriate two alpha-numeric characters from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming
This completes the procedure. See
Table 8. ACK Character Setting Examples
STEP ACTION
1 Desired Character/Value
2 Hex equivalent
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT ACK CHARACTER SETTING
Scan Two Characters From
5
Appendix E, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
Setting to previously defined characters such as XON, XOFF, or host
commands conflicts with normal operation of these characters. 8-bit
data is not recognized when the option
Data Bits.
NOTE
ASCII Chart on the inside back cover of this manual to find the hex equivalent
for the desired character/value.
Mode.
Keypad, that represent the desired character/value in step
will cause a two-beep indication.
Mode.
ACK
0x06
'0' and '6'
Table 8 for some examples of how to set this feature.
EXAMPLES
$
0x24
'2' and '4'
ACK Character
Data Bits
has been set as 7
Appendix E,
1 above. The second character
@ >
0x40 0x3E
'4' and '0' '3' AND 'E'
251