Intercharacter Delay - Datalogic QuickScan Lite QW2100 Product Reference Manual

ENTER/EXIT PROGRAMMING MODE

Intercharacter Delay

This parameter specifies the intercharacter delay between the end of one character and the
beginning of the next. The delay can be set within a range of zero (0) to 990 milliseconds in
10ms increments. A setting of zero specifies no delay.
page 258
$CR21C
Select Intercharacter Delay Setting
Make a mistake? Scan the CANCEL bar code to abort and not
save the entry string. You can then start again at the beginning.
Product Reference Guide
for more detailed programming instructions.
This feature applies ONLY to the Keyboard Wedge interface.
NOTE
00 = No Intercharacter Delay
DEFAULT
Intercharacter Delay
See Intercharacter Delay on
$CR21C00

Intercharacter Delay = No Delay
~
CANCEL
61