Parity - Datalogic QuickScan Lite QW2100 Product Reference Manual

RS-232 ONLY Interface

Parity

This feature specifies parity required for sending and receiving data. A parity check bit is the
most significant bit of each ASCII coded character. Select the parity type according to host
device requirements.
•
•
•
DEFAULT
$CR2PA01
Parity = Even
40
Select None when no parity bit is required.
Select Odd parity and the parity bit value is set to 0 or 1, based on data, to ensure that an
odd number of 1 bits are contained in the coded character.
Select Even parity and the parity bit value is set to 0 or 1, based on data, to ensure that an
even number of 1 bits are contained in the coded character.

ENTER/EXIT PROGRAMMING MODE
$CR2PA00

Parity = None
$CR2PA02

Parity = Odd
QuickScan Lite QW2100
TM