Enable Character - Datalogic QuickScan Lite QW2100 Product Reference Manual

RS-232/USB-Com Interfaces

Enable Character

Specifies the value of the RS-232 host command used to enable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected. See
page 256
$CR2EC
Select Enable Character Setting
52
for more detailed programming instructions.
Setting to previously defined characters such as XON, XOFF, or host
commands conflicts with normal operation of these characters. 8-bit
data is not recognized when the option
Data Bits.
NOTE
0x45 = Enable Character is 'E'
DEFAULT
ENTER/EXIT PROGRAMMING MODE
Enable Character on
Data Bits
has been set as 7
QuickScan Lite QW2100
TM